Dol starter single line diagram

November 13, at 3: A fourth contractor is required to place the resistor in circuit before opening the star contactor and then removing the resistors once the delta contactor is closed. V1 and V2 is having same phase. Remote stop pushbutton NC contact 5. Abdul Mannan Mollah May 06,

Uploader: Shakagore
Date Added: 21 August 2005
File Size: 48.63 Mb
Operating Systems: Windows NT/2000/XP/2003/2003/7/8/10 MacOS 10/X
Downloads: 63339
Price: Free* [*Free Regsitration Required]





How do I connect a direct on line (DOL) starter to a single phase motor?

I have gone through this basic article. Overload relays are employed on a motor control to limit the amount of current drawn.

Normally it gets one phase constant from incoming supply Voltage A1. July 12, at oine V2—W2—-U2 For Reverse also known as counter-clockwise rotation we need to wire as follows: August 17, at 6: Shafiq Ur Rehman says: We have upgraded the xfmr and the wire from the utility but still have the brown out.

Direct On Line Starter | Electrical Notes & Articles

Basic information about dol starter. Follow Blog via Email Enter your email address to follow this blog and receive notifications of new posts by email. Insteed of going for each and every switch.

Overload relay output terminals are connected to the motor terminals — U1, V1, W1. Fred Yeung Jun 11, July 4, at 1: At some point during starting it is necessary to change from a star connected winding to a delta connected winding.

Star-delta motor starter explained in details | EEP

The power circuit consists of a three-phase main supply with a fuse unit for protection purposes. September 19, at 6: February 21, at 4: Join 11, other followers.

This requires the use of a fourth contactor and a set of three resistors. February 13, at 9: Sibi Paul Mar 17, Dear Sir, As per your given Fig. January 30, at 4: Read ing and understanding electrical drawings Electrical drawings can represent anything from a single-line power distribution, to a power or control circuit, and are prepared using various symbols for electrical devices and their interconnections with lines representing conductors or wires used for interconnections.

It have decelerate time setting to stop the motor. Post was not sent - check your email addresses! The schematics here depict only the fuse.

Somnath Mukherjee Jun 08, Your guide was very informative and helped me change a new lathe that was originally wired for three phase to a single phase supply with a VFD. September 21, at 5: November 23, at November 22, at Relay coil gets supply even though we release Start button. They can be ideal in many precise sihgle. The NC contact of such a push button is connected in series with the other control contracts such as overload relay.

4 thoughts on “Dol starter single line diagram”

  1. I can not participate now in discussion - it is very occupied. I will be released - I will necessarily express the opinion on this question.

Leave a Reply

Your email address will not be published. Required fields are marked *